Posts

Chosen Solution Here is images with the information and showing the problem Plasma info https://imgur.com/gallery/ao6eI I have read that it could be either the logic main board, or one of the three logic buffer boards along the bottom. I have also read something about a TAB error? Though I am not sure what exactly a TAB is. @amammoth this does not look like a tab error at all. This does look like a a bad X-board or a bad IC on the flex to the panel....

Chosen Solution System Information reports “No information found” for Bluetooth. I have replaced the bluetooth board. I have replaced the cable from the board (+ camera, + sensor) to the motherboard. I have confirmed the camera still works. I have carefully replaced the aluminium foil over the exposed cable shielding. I am presently starting up the machine with no display and using an external display (just in case this information of of use)....

Chosen Solution I purchased a new Nikon lens ( AF-P 70-300 ED VR) for my D7000. When installed both the image in the view finder and any picture are very blurry. It does not respond on AF. I have updated my D7000 to the latest firmware version however nothing has helped. Apparently the D7000 doesn’t support the new AF-P lenses. Manual focus may or may not work, but I recommend returning it and getting the old AF-S version....

Chosen Solution I have a Bowers Wilkins A7 wireless speaker. It can’t be connected successfully now either with WIFI, wire, USB or AUX. The red light just keep flashing indicating the connection issue. Resetting the device didn’t work either. It is an old device with little information on how to fix this. Is there any way to check the root cause of the issue? @Shawn Chen The only thing I suggest now is to open the speaker and check for any obvious problems on the systemboard....

Chosen Solution Hi, I removed the antenna wire a little too hard when I was going about replacing the screen and now it won’t connect to the bottom board, I assume I just need to solder it onto the bottom and everything will work fine. But I thought I’d ask just incase, has anyone else had this issue and fixed it by soldering? Hi was it just the wire that was broken?...

Chosen Solution The camera wont load or any of the camera apps. I click the camera button and it flicks across to the camera screen but the camera icon is greyed out and then it quickly closes and returns to main menu. Same thing happens if I try and load from Camera app, Lumia Camera app or Nokia app, even my flashlight app does the same flash screen then it crashes....

Chosen Solution Hi, I have a really huge fungus section on my sensor and have already tried cleaning it in the service centre. But failed to get rid of the fungus completely. It keeps coming back. I don’t really trust the service centre guys.. so I thought I would clean it by disassembling my EOS 60 d at home and clean the sensor myself. I have been watching a lot of videos and it seems not really a tough job....

Chosen Solution On a pre-unibody MacBook, the trackpad is part of the top case (if I’m not mistaken, they are inseparable?), but I was wondering it the newer multi-touch glass trackpad can be fitted or somehow hacked onto any pre-unibody model. With the arrival of Lion, very restricted access to gestures is a serious disadvantage! I have thoroughly researched this on Google but I cannot find a solution, not even a software-based one....

Chosen Solution Hello guys. First of all, i want to apologize for my bad English . I am portuguese, but I prefer to describe my problem in English in order to have better chances of help. So, i got a Samsung Tab3 10.1 and suddenly it start to show some charging issues. Last week, i stopped being able to charge the tablet. I thought that was the battery dying, so i changed it for a new one....

Chosen Solution “USB device drawing too much power” error on startup with no devices connected. dear all, I’ve been doing some upgrades to a Mac Mini Model A1176. During the process I accidentally cooked the sound card but have replaced it and have sound working again. However I believe this accident has damaged something else on the Mini as I now get the above error every time on startup. This is irrespective of whichever OS i have installed; i....

Chosen Solution Abs and brake light always flashing…. help! The ESP led is on with the abs ? The ABS system needs many informations to work properly, like the speed of each wheel, how many persons are in the car… So if one of the sensors fails then the ABS won’t work, you have to check them using a pc and a diagnostic box. the only real thing you can do is double check the sensor, make sure its not dirty, then check the fuse, if that’s fine, then I would suggest taking it to a mechanic....

Chosen Solution So I’m working on this reclamation project for this 13” 2010 MacBook Air. About 1/4th of the screen is broken, so normally I have it hooked up to an external monitor, which works fine. Problem started when I replaced the keyboard recently after it’s power key stopped working. I did the replacement fine, the keyboard now works, but the computer is ghastly laggish when it’s doing anything. I burned Apple hardware test onto a bootable USB, and ran the diagnostic, but the error code that it spits out is half-blocked from the screen damage....

Chosen Solution My iphone switched itself off earlier and then the Apple logo appeared on the screen like its about switch back on but nothing happened, the apple logo continues to appear then fade out. I’ve tried to reset the phone by holding in the buttons, I have tried disconnection the battery for a short while but still no joy so I hooked it up to my computer to try putting it into DFU mode but it’s not being picked up by iTunes....

Chosen Solution Every time I download an app I get a message not enough storage so I bought a SD card that has 32 GB and I still get this message. Help!!! Hi, By default Andriod OS installs apps in the internal storage area. Have you moved any of your personal data e.g. photos, music, videos etc from the tablet’s internal storage to the SD Card to create space in the internal storage area?...

Chosen Solution I was replacing my LCD screen on my macbook pro and mistakenly unplugged the LVDS connector from the LCD screen when the laptop was on. i used a difference LVDS connector and still no luck. Looks like i burnt out the Backlight Fuse, as the screen slowly went dim and then completely black. If i shine a flashlight on the back i can see the screen. So the backlight is not working....

Chosen Solution So I just replaced both o2 sensors & the governor pressure sensor & solenoid & my check engine light keeps on coming up for the govenor pressure sensor & solenoid! Now how is that possible? I changed them correctly, do you have to reset your jeeps ecu after replacing sensors? If so how? & I have all the symptoms of a bad transmission speed sensor but no code for that, just the governor pressure sensor & solenoid!...

Chosen Solution Hi, I have installed the battery in my 2012 13 retina Macbook Pro. I found that the battery take so long to charge to 100% (~5-6 hours to complete a charge) and when I was using it the battery percentage suddenly drop from ~50% to 6% and after it can stay like that when I use for 1 hour and the battery completely died. I have calibrated for 2 times and still didn’t work please follow up....

Chosen Solution Battery “47% (plugged in, not charging)” what do I do? Ask a repair technician to check a power relay/controller. Can be that. Or the place that connects battery to MoBo, or paths between relay and battery. All that is possible only if your battery isn’t discharging while your laptop is in use (be that work with docs or heavy duty like gaming/3D-modelling). If your battery is discharging, then it might be an AC adapter issue....

Chosen Solution My iPhone 6 suddenly stopped charging, I’ve tried different power outlets and different chargers. My first guess would be that it’s either the battery or the charging port. However, if I turn my iPhone off, and plug in the charger, it starts up. This gives me a hint that the charging port probably works and it’s the battery that is broken. Does anyone have any ideas? Prices aren’t that expensive for either the battery or the charging port, so perhaps it’s easiest to just change both?...

Chosen Solution I bought a used HTC 10 that said it had a dead touch screen zone at the bottom of the display. Using a drawing app you can see there is a half inch tall dead touch area that spans the entire display. Visually the LCD works. The odd thing is sometimes it is dead and sometimes it works. On HTC’s Android 7 and 8 the bottom half inch of the screen doesn’t work on the home screen or in apps but it 100% works for the keyboard....