Chosen Solution I have mi 5s plus and this device globalrom and every 5 minutes auto rebooting. Many times i flash and update also but probably is same. Any suggestions plz? the main board could be spoiled, try to replace it, you can find some cheap second-hand mi 5s plus or parts easily on taobao https://world.taobao.com/
Chosen Solution I have tried to use ifixit guide to replace battery in my iPhone 5s. When I got to steps to remove adhesive tape, unfortunately the tape tabs just went off (just tore off) without removing adhesive from underneath the battery. These are steps 21-25 here: How to replace the battery in your iPhone 5s How can I still remove the old battery? Heat up the rear of the iPhone were the battery is situated the aluminum part....
Chosen Solution How to fix Battery turns 0% when plugged in then it shuts down saying there is no battery. https://www.amazon.com/hp-pavilion-x360-… looks like a quick and easy fix. https://support.hp.com/us-en/document/c0…
Chosen Solution I installed the batteries, plugged it back into the housing and it immediately headed up and started smoking. I pulled the batteries out and reconnected them. Now I just get an orange flashing light when I press the buttons. What’s up? Smoke indicates that either the batteries or (most likely) part of the shaver’s electronic components have burned up. This means that you have further repairs to perform. An orange, flashing status light normally means the battery is dead or about to die, according to the manual (link below)....
Chosen Solution I bought the 3.8GHz 8-core 10th-generation i7 variety 2020 iMac, with the base config 8GB of 2666MHz DDR4 memory. I’m now trying to install 2x 16GB sticks of HyperX HX426S15IB2K2 (Kingston) and have discovered an impossible optimisation problem. The stock RAM comes as two 4GB sticks. I tried the following configurations of RAM stick in each slot (remember slots 1 and 3 are DIMM 1 and slots 2 and 4 are DIMM 0): Empty4GBEmpty4GB Result: 8GB @ 2667 MHz 4GB16GB4GB16GB Result: 40GB @ 2133 MHz 16GB4GB16GB4GB Result: 40GB @ 2133 MHz 4GB4GB16GB16GB Result: 40GB @ 2400 MHz Empty16GBEmpty16GB Result: 32GB @ 2667 MHz Here’s a photo of the last configuration to provide physical orientation....
Chosen Solution Hello, I am wondering which liquid you are using to remove the glue of the bezel and also OCA on the LCD from iPhone X-11 Pro Max. I was using 8222 but someone told me that 8222 might cause damage to the flex which actually did to a few LCDs that I worked on. The person recommend me to use 530 liquid but I don’t think we can get that in the US....
Chosen Solution This Galaxy S6 LCD seems to be defective… I was just wondering if anyone had seen anything like this before. Black pixels seem to be slowly but surely taking over the screen. There is no touch response either. Did you try a new LCD? That looks so weird, like there’s a lot of dirt and dust inside the screen.
Chosen Solution I have iMac 27 late 2013 in startup i can hear the start sound and the system is working but black screen, usually when unplugged from electricity and left for few hours it comes back to itself. but now even this is not working . start/ off button is working any ideas ? Not good ;-{ Either the power supply or the logic board or both could have a problem!...
Chosen Solution It’s a samsung UN50H5203AFXZA model version NH03.. Screen went blue while was on. The sound is on I do have good back lights. Iv replaced the tcon main and power boards. which I ordered of from shopjimmys. I do not see image with flashlight. I also reset with power button. @ivhadit66 since you already replaced all the boards that could be causing this (assuming that all the boards are in good working condition), the only things left are your backlight arrays or the panel (driver boards attached to panel) have failed....
Chosen Solution I repaired my own Nexus 7 when it cracked (twice, don’t ask), but when it cracked even slightly it was unusable. This Samsung Galaxy Tab S 10.1 inch still works though the glass looks like a maze. Is just the outer glass separable from the digitizer, or do I have the wrong idea and need to replace them both? The Nexus was intense to repair, but with caution it was easier than I thought it would be....
Chosen Solution After buying brand new Canon 80d I have bought third party battery grip. Camera was working more than fine with battery and battery grip. After removing grip camera can not work without it? Probably it is because of using third party accesssories but in my oppionion it should not be a problem. Is there any fix, what should I do. Also important information is that I have been using third party batteries and that the camera was sending the info that I might be using not genuine batteries?...
Chosen Solution My device had fell down and now it has 4 to 5 cracks in screen but still touch sensing and all the images are proper view. Which part of screen is broken and which one to replace??? Change touchscreen with lcd. When you change the touchscreen, i do not know any glue in all inside touchscreen lcd. The more difficult. See tutorial ini YouTube for perfect jobs.
Chosen Solution My macbook is not turning off after i used faulty charger. I don’t have any apple store near me in pakistan. Guy at the repair shop opened laptop and there was sparking near charging port He said processor is faulty and it is not working. He will replace processor in 200$. My question is can processor stop working because of sparking or is it replaceable? Thanks in advance...
Chosen Solution I have a Samsung tab SM -555.The battery is still good but sometimes (a few times) I found it switched off and I dont know why (olso if I think the problem maybe can be the mini usb.One time after switching off the tab wont witch back on but afer “mooving something in the mini usb " I was able to power on again and use it (before I was able to power n the tablet only if the tab was connected at the charging cable)....
Chosen Solution This is not my laptop, but a machine I maintain for the owner as I’m their IT department. I went to move the laptop, and noticed this gap near the bottom cover where I know the battery lives on the Y700-17ISK. I apologize for the rough photos, but I need to talk to the owner first before I open this as I need to warn them it may become a desktop if I open it as if I see the battery is expanded, I’m not putting it back in and she’s buying a new battery....
Chosen Solution I have a 2001 jeep grand Cherokee Laredo and all of a sudden the headlights stopped working but if I pull the lever for high beams they work but dont stay on. What can i do? Hi, There may be a problem with the headlight light switch (aka left multi function switch unit) or perhaps the Body Control Module (BCM) that actually powers the headlights when the switch is operated....
Chosen Solution Hi, I have a 2010 17” MacBook Pro (not the dreaded 2011 MacBook Pro…). Recently, keys in the top-right hand section of the keyboard have started repeating continuously. The worst are the volume up/down function keys, but also others such as the “\” key. I thought that the keyboard was probably the problem so I transplanted the logic board into a spare identical 17” MacBook Pro case that included its own keyboard, and the problem moved with the logic board....
Chosen Solution My question is about the 72" version of the same TV Model HL72A650C1FXZA TV Serial: AMBF3CKQB01234B Version: OG01 Came into room while kids were watching TV, and the screen was frozen. Picture was clear. No sound. TV would not turn off by remote or front-pannel stand-by button. Had to pull the plug. Plugged in and re-started, and the TV screen would not come on. Standby light comes on, then disapears when power button is pressed....
Chosen Solution i bought a dell inspiron n5110 laptop yesterday. i can hear buzzing noise from ac adapter brick when its plugged to the laptop, i can hear it of 20cm distance, and when i disconnect it, the noise reduces. is it normal? or i should replace it? The buzzing noise that you are hearing is normal to that point that you should be able to hear it when the brick is next to your ear....
Chosen Solution So I stupidly poked the top microphone with my sim card ejector tool. The microphone is still fine but given that the phone is only new I’m just generally worried. Is there anything I should be worried about? Thomas “The microphone is still fine “ so don’t get any gray hair until it does give you issues (unlikely) If you would have damaged the mic it would already have failed....
