Posts

Chosen Solution recently changed the back glass, camera lens, battery and screen of an iPhone x and now the front camera, rear camera and flashlight is not working. if its important I lost 2 short screws for the little plate holding all the flex cable connections in place. i have tried looking to see any broken connection but everything seems good If you have used a laser cutter to remove the rear glass and not taken out the cameras and logicboard, you most likely have damaged those components....

Chosen Solution So my galaxy s10+ fell a small amount and the bottom half of the screen started flickering black, it seems to react with the phone brightness, the flickering gets worse if the brightness is raised all the way but I’m not sure because it sometimes doesn’t do anything, the phone screen had 2 small cracks before this happened and when this happened there was no visual damage, I tried everything and nothing worked....

Chosen Solution In the recently hit earthquake in our country Nepal, my Moto G 20014 (XT1064) fell of my shelf but no damage was seen in the screen. However, later I noticed reduced speaker sound, specifically the bottom one. Then I found that the speaker was not working at all. However, if I gently hit the backside of the phone where the bottom speakers are located, it gave me output for a while and then again stopped working....

Chosen Solution We moved into a brand new house. About one month after moving in my dryer started squeaking then would only blow cold air. We decided to buy a new dryer instead of repairing the old one. I used the new dryer for a week and a half with no issues. Now the dryer keeps tripping the breaker. I will reset the breaker, the dryer will run for a couple of minutes & trip again....

Chosen Solution Hello! My N23 chromebook is cracked, so I have two questions: 1-somebody can show me where I could buy a new LCD screen? Just to avoid buying the wrong one. 2 - I have some experience in replacing LCD´s, but does somebody have experience precise with this model? It would be way faster with a guide :) Thank you so much! (Remove cover and Disconnect Battery) Remove the front LCD Plastic Cover, Remove 4 LCD Screws and Install a new one....

Chosen Solution I own mid-2010 27” iMac While attempting to do the HDD swap, I broke the LCD temp port that’s attached to the logic board, and now the cable doesn’t connect properly. As a result, the fan is going maximum. The sensor cable is fine, it’s that port on the logic board that’s broken. What’s the part number for this part and what would be the best way to fix this?...

Chosen Solution Hello, I have a brother ‘MFC-J4420DW’ printer, since a week or two it is unable to find any SSID/network when I try to set up the Wi-Fi. It was connected and working before but it could not connect the Wi-Fi anymore so I tried the Inst wizard but it never shows any SSID’s anymore for any network. So it can’t be just a problem with my router/network I think....

Chosen Solution Hi, My built-in trackpad is not working after battery replacement for my MacBook Pro 2015. My keyboard is working though, so does that mean my cables are ok? I was very sure the acetone didn’t touch the trackpad board at all. Could the acetone have gotten into the trackpad cover plate???? What is happening? Do I need to replace my trackpad now? Thanks, Gary Somehow your trackpad has failed....

Chosen Solution I am getting this error on my zenfone 2, is there anyway to know if this is due to a hardware problem or a software problem? Any place where i can buy the camera replacement? My country doesn’t have Asus service Actualización (25/07/16) I have disarmed and note that the front camera was incorrectly connected , connect it again but the error persists, something I can try? you can use the calculator test benchmark for see if is a hardware problem....

Chosen Solution I have a very dim and banded 20” LCD display on my Early 2009 iMac and I have a 2007 20 iMac with a good display just gathering dust. Can I swap out the displays? Hi Roger, Based off of the Everymac pages for the 2007 and 2009 20” iMacs, I’d say it just might be feasible. If you’re willing to open the 2007, you could compare the connection cables as seen in Step 8 of the 2009 20” iMac teardown....

Chosen Solution hello all, i have an imac 2019 with 1t pcie drive and i want to replace him with ssd 2.5 4t is it possible? thanks! Review these two guides: iMac Intel 27" Retina 5K Display 2019 Blade SSD ReplacementiMac Intel 27" Retina 5K Display 2019 Hard Drive Replacement Now keep in mind the PCIs/NVMe blade SSD is almost twice as fast as the SATA III (6.0 Gb/s) HDD drive port (with a SSD)....

Chosen Solution I have tried to re-enter the network, once done it gives me 2 options forget or done. I have tried refresh networks, add networks and saved networks to no avail. It was fine up to a week or so ago. Well, not quite enough information to perhaps help you with an answer. A few questions: What device / computer are you using to connect to the wifi network? What system is the device / computer running?...

Chosen Solution As title says. Setting up Hey Siri does not work. But if I simply hold down the home button and talk to Siri it can hear me fine. Am I right in saying Siri listens through the earpiece mic for both of these? Maybe the repair guide below can give you a hint. How to Fix iPhone 7 Hey Siri Not Working

Chosen Solution I checked to see if the fuse is broken, but I can’t hear any sound from the engine. Do I need to replace the part? My car is 2004 opel astra h Check to make sure you’re getting voltage at the pump. Pull the plug off, put your probes on the -and + terminals, and have someone activate it while you watch. If you see power, then replace the pump....

Chosen Solution hi all, pls look into my query regarding unable to install app in my HP touchpad. While I am installing any app from app store there was error msg of install failed after completion of application. so pls look into this and resolve this case as its very much urgent. This link will show you how to fix your problem so you can update the app catalog . https://developer....

Chosen Solution Hello, I just finished a screen replacement on my Apple Watch Series 3, but the screen is pixelated with a bunch of different colors. Any idea what would cause this? Defective screen, or one of the connectors maybe? I’d like to get this fixed soon so I can use my watch again. that looks like a bad screen. I would try reconnecting it again if you replaced it yourself....

Chosen Solution Three slots were accessible and empty when I tried to boot it up. The last slot (which needs near-complete disassembly of the laptop to access) had a 2GB chip. The laptop failed to POST BIOS - I got steady LED lights and a battery light if a battery was present. Wasn’t sure if this 2GB was defective. Pop in two more matched 2GB chips (matched to each other but not necessarily the lone, inaccessible third 2GB chip) - laptop posts and recognizes all three 2GB chips, giving me 6GB....

Chosen Solution Hello, First let me start by saying that my device is not a Chromebook Thinkpad 13 but a regular Thinkpad 13 but I couldnt find the model. The issue is that it is charging on and off every couple of seconds. The led also blinks. I changed the dc/jack flex and I tried with 2 other known good chargers to no avail. The laptop will not boot with the battery unplugged....

Chosen Solution I replaced a battery to a “supposed” new battery for an iPhone 6 and it resulted in a different issue. Now it takes about 30 minutes to turn on while it’s charging and then it takes like 30 minutes to charge up to like 17% and jumps all the way too 100%, then i take it off the charger and the battery lasts like 10 minutes and dies at 80%....

Chosen Solution Last week I checked my oil and got distracted and forgot to tighten the oil cap. I started up my T2300 Crafsman and quickly saw oil squirt up after about 1 minute if mowing. I then checked my oil and it was low, so I added oil. I checked it and it was above the fill on the dipstick. I didn’t do anything about it. I started cutting. Ran fine for about 30 minutes of cutting....