Posts

Chosen Solution I recently replaced the battery on my iPad Pro 10.5 with an aftermarket battery from amazon. The iPad would turn on and function fine but then shut off after a few minutes and reboot. I read these forums and considered the new battery was bad so I bought another one. The same rebooting issue keeps happening. The battery percentage is a bit erratic jumping +/-5-10% randomly and without the corresponding use or charging that would normally account for a battery’s percentage to fluctuate....

Chosen Solution Hi i have samsung galaxy a500G/DS mobile. screen is broken and touch is not working in my mobile. and i locked my mobile using screen lock. usb debugging is not actives in my phone. and OTG is not worked now. how can i recover all data in stored my phone. please give me any suggestion . @devilking78626 since you already tried to access it without your screen, you know it is not working....

Chosen Solution The shutter works but there is no picture that shows up. Nothing sounds loose in the camera. But either I dropped it in the past or I banged it. Again the clock is set right, the shutter works, just no picture and the error word is the problem @mikeschultz the “err message” is commonly caused by a failed switch contact in the aperture control unit. Use this document Nikon D80 SM to work on your camera....

Chosen Solution I downloaded Windows 10 then tried to go back but what happened is that it deleted every file including the booting files for it. Is there anyway I could get Windows 10 or 7 back or any way to make this work because I just bought this computer from a pawn shop. If the Boot Files are missing you need to reinstall the system. However, you might loose all your data....

Chosen Solution The only thing to remedy the god awful sound is to turn off the active noise cancelling via the Headphones app. Is there a manual on how to fix this? Hi As far as I know the only way this is fixed is by ether reseating the microphone or replacing it The Sound is is usually y caused by the microphone picking the frequencies up incorrectly Hopefully this helps Any questions please ask Thanks:-)

Chosen Solution I recently replaced the screen on a Apple watch 3 GPS with a donor screen from a series 3 LTE, i replaced the gasket and sealed the watch up, the display works great but now i am having problems with Bluetooth connection. the watch will connect to my phone and pair, but will loose connection when my phone is in my back pocket and the watch on my arm, i cannot walk away from the phone without loosing signal....

Chosen Solution If I buy a replacement battery kit, are new screws include for my early 2011 MacBook Pro 15 inch computer? Did you loose it or break it? The assumption is you will reuse the Tri-point screw. There is no replacement screw in the iFixit battery kit. Update (05/28/2019) Here’s the screws: MacBook Pro Unibody Lower Case Screw SetUnibody Macbook Pro 15" tri-lobe battery screw (09-Mid 12)

Chosen Solution My Asus K55V laptop not turning on or no lights blinking when connected to power adaptor or with battery. I shutdown and put it in charge overnight and morning it is not getting On. Plz help….Thankz in advance ☺ Oh, I have this other solution to make your laptop ASUS on. (Based on my experience lol) I used my laptop and do whatever and suddenly my laptop was shut down....

Chosen Solution When I connect the aux jack, my jbl e45bt turns off and does not turn on until I disconnect the cable @mjmm possibly a shortened cable or jack. Try a different cable and if that does the same you may have to disassemble and check the jack I thought this was an intentional design to prevent damage to the bluetooth DAC if there’s a wired source plugged in. Am I wrong?...

Chosen Solution Hello, I have a problem with Macbook Pro Retina 13 inch model A1502. I changed the LCD with a new one. But after the replacement to backlight is not working. Lcd is working, because I can see something when I put flash from my iPhone on it. Who can help me with my problem? How can I fix the backlight? Thanks! Hello, I think that it’s a connector on LCD or motherboard pb....

Chosen Solution Hello everyone, My redmi note 4 doesn’t charge correctly. It stays at 2%. I thought it was the battery so I changed it but it didn’t fix the problem. Do you think it comes from the charger port or from the other internals? What do you reckon I should do? Thanks Guillaume Bregeon since you already replaced the battery and it still shows the low charge it could be the connector but it could also be related to a bad PMIC ....

Chosen Solution Hi Everyone. I have a Macbook Pro 2011 as above and recently I took it to remove OSX and re-install when found out it wasn’t working as before. In fact wasn’t working at all. Hard to start the OS and when started slow like a Windows PC. Checking upon battery charge I noticed it was empty and no charging was being given. I left the Mac idle for a long period and probably the battery was decayed it charge to zero or near that....

Chosen Solution I followed the guide step by step and when I assembled it all back the screen now flickers at the bottom edges. Is this the screen of a ribbon issue? yes. disconnect battery and reseat LCD connector and be sure ribbon cable is not bent. Reconnect battery. Turn off auto-brightness. Hard reset If this still doesn’t solve, it is damaged LCD connector. jessa Hello. Yesterday I was in an independent repair shop and my iPhone 5S screen was flickering heavily after battery replacement, but the shopkeeper said that it will disappear after cca....

Chosen Solution Hello. This is my problem. I can turn on my dad’s notebook only if i open DVD-ROM immediately after pushing power button with black screen then normaly power button and WAN light normaly. If i dont open DVD-ROM or remove DVD-ROM notebok will rebook in 1 sec in loop after DVD-ROM starts rotate. When he is turned on caps lock blinks 1 per 3 sec, after few minute blinks power button and WAN 1 per 5sec....

Chosen Solution Hello, I have a Samsung S6 Active, while I have the phone in my pocket. I believe that something hit my phone but I don’t know for fact. I try the up volume, power, and home button. As well as bottom volume, power, and home. But they both still have no effect. It’s still show red notification when charging and green notification when complete. I thought it was because of the overheat from being in my pocket during a hot weather might cause it....

Chosen Solution Hi, can anyone help me with this problem? After a long period of time of no use i wanted to use my laptop and after i reinstalled the OS, when i turn it on, before the BIOS , it comes with approx. 30 secs of black screen, i had changed the RAM and the HDD with an SSD and the only change was a few secs o black screen ....

Chosen Solution Hi! I accidentally tipped over a bottle of Worcester sauce fell on top of my phone while putting away groceries. Now there is a brown line vertically on my phone, its very noticeable. As well as dead pixels near the end on the edge of the phone. Is there any way to fix this? what you can do is if there is no physical cracks or damage on the phone then call samsung service centre and if your phone is still in the 2 year warranty they can replace the phone or repair it but they will send a courier free of cost and pick up the phone....

Chosen Solution Hi, I would like to be able to create a bootable macOS USB flash drive, but it seems that the only official way is to use a Mac. I don’t have a Mac, so is there a way to create a bootable USB macOS drive in Windows or Linux that doesn’t involve hacked ISOs and whatnot? Please note: I had to select a machine for this question, so I just selected a 2012 Mac Mini....

Chosen Solution I have a Mac mini mid-2011. I installed an SSD as the second drive. It works but I have broken the IR and Fan connectors - sheered them off at the logic board. Is it possible to repair these two connectors with “micro-soldering”? What tools do I need to do that please? @cooker47 that will depend on how they are broken and if they destroyed the solder pads. If so, you will most likely have to run some jumper....

Chosen Solution Wanting to know if this is fixable… Apple Watch Series 1 had small crack on screen then was submerged in water. It still worked after but battery was low, same day I charged watch it got extremely hot and never turned back on… I’m afraid I fried something! What if anything needs to be replaced in order to fix it? I have nothing to lose… already ordered my daughter a new one....