Posts

Chosen Solution So, I was cleaning a customer Macbook Pro the other day and happened to notice that when the Battery Sense Connect cable was removed that it yanked one of the pins out with it. The pin that was pulled I had thought was the bottom (In the picture, and also in relation to the motherboard, it’s the closest to the battery) pin and from what I can see as far as which data paths are used, doesn’t actually do anything....

Chosen Solution Ive has them for a little while now, but every time they aren’t plugged in they don’t do anything but when I am charging them they blink red and if I hold them in for a while they just stop blinking I would recommend try resetting them following this guide: Reset your Beats earphones. Do make sure you’ve allowed your headphones to fully charge using an iPhone (10w) charger or better yet a iPad (15w) charger....

Chosen Solution Hi, I just replaced the screen and battery on my iPhone 6 at the end of the repair the screen did not turn on. I unplugged from power and removed the screen- I noticed one of the screen flexes-the horizontal one was slightly loose- and the area over the processing chip is very hot- what is the best course of action now. Did you power it on without the display on ?...

Chosen Solution This same problem just occurred to my TV (same model 47LG70). After removing the green rubber sheath (not sure why that is even on it), the varistor looks OK. Everything on my circuit board looks ok. Did replacing your varistor solve your problem?? Any other help appreciated.

Chosen Solution Hello everyone. I have a Dell Inspirion 7000 series - 7737 Laptop in my repair shop. The clients could not get the laptop to boot. ( that was due to damaged o.s. install ). I am able to boot the laptop 50% of the time running windows 10 pro. the other 50% it freezes. Also once the system is booted it runs at about 90 - 100 % disk full....

Chosen Solution We’ve been troubleshooting a leak in our Bosch side by side fridge freezer for a while (model number KAD62V40GB/13) which we finally found was a blocked drain pipe for the excess water from the freezer, we’ve cleared the blockage, put the freezer back together and it’s all working as expected, except for the fact that the front display is now showing E 47. Usually it would just display the temperature figures for the freezer and fridge (note these are not actual readings just what they should be)....

Chosen Solution Hi Dears, I have broken the plastic levers where RAM is located, do you know where I can buy this piece? Thanks Marco Sadly, the Ram slot is not a user-replaceable piece, the RAM slot is soldered on. I don’t even think it is for sale anywhere. I would try to keep the RAM stick in place using kapton tape, if possible.

Chosen Solution Hi Guys Can I replace the 1.3Ghz logic board with the 1.7Ghz logic board? Apart from the installation is there anything else I need to consider? MacBook Air 13” Mid 2013 Thanks for your help Sure! Its possible, but given the fact Apple might be rolling out a newer version at the end of the month you might want to wait until you see what Apple brings out. Here’s the part: MacBook Air 13" (Mid 2013-Early 2014) 1....

Chosen Solution Can I retrieve pictures from a water damaged Google Pixel 3a XL? If the damage isn’t too bad of your motherboard, you can try to buy a battery and replace it. You can also use rice/cat litter to absorb water.

Chosen Solution Ice maker motor not working to dispense ice. Is there a way to check the switch you push your glass against? How do you sure there is a motor issue in the ice maker. The switch or any other part could be damage. Please bring the complete unit to the brand service station. After opening the unit anyone can check the exact issue.

Chosen Solution Hi, I think I already know the answer to this questions, however I’ve been given a 2017 iMac with a Firmware Password set won’t boot up at all (just showing the Firmware Password Lock). The previous owner is convinced that they have been “Hacked” and the Malware has Set the Password. As far as I’m aware, you can’t set the Firmware Password from within the OS. I’d could see a drive Encryption happening but not a Firmware Utility Password....

Chosen Solution Hello everyone,, I recently replaced a front camera/sensor flex on my iphone 8 plus. I know that true tone will disappear., but also can’t add any finger print to my touch id. Every time i try the screen just flicker/jumps up and down. Please any help appreciated. Thanks I can think of a couple things. If it was just the front camera flex you replaced, my inkling is that the home button flex which goes from the display to the logic board may be pinched or was damaged during the repair....

Chosen Solution Opened my sunroof all the way and now it wont close. Fuse and motor both work. Acts like passenger side is off track as the driver side tries to move. Liner is down to view but am at a loss as to what to do from here. Ashley, It may have came partially off the track, there could be a bad cable, roller, etc. You may be able to get it closed, carefully with an assistant by pulling/wiggling on it while pressing the close button (be very careful to not pinch fingers or hands) pull hands out quickly before completely closed and use palms of hands on screen to help finish closing....

Chosen Solution I can’t hear incoming calls well, the volume is very low even though the volume is turned up elsayed.eps45 you did nto tell us how it sounds like with a headset. Anyhow, this could be a speaker issue and you may consider fixing it. To get into your phone use these guides Pocophone F1 Repair and/or check something like this video to work on it.

Chosen Solution Due to some overheating issue, I assume, there are two corners that have slightly been raised, just enough to fit a nail between with some effort. I would like to re-seal it but ideally not buy a whole new back piece as it is still intact. Can I just re-heat it? Do I need to apply new glue? Is this something a mobile repair shop would be able to do or do they only offer full replacements?...

Chosen Solution Hi, I have a great iPhone 6. Apart from a small crack in the screen it preformed excellently over the past 2 years. Recently the battery behavior became crazy : the phone displays 80% charge , power off with 0%, connected to AC and after 2 minutes shows 40%. What could be the cause? Battery U2 Guy I have had a similar problem with my iPhone 6. What worked for me was re-calibrating the battery....

Chosen Solution I replaced the battery in my iPhone 6s and all went fine; however, the Battery Health Indicator (Settings, Battery, Battery Health) no longer functions. Is there something about the ifixit replacement batteries that make them incompatible with this function? Or is there something I need to do to get this functionality back. Try a systel restore with iTunes. If that doen’t fix your problem, try to boot your iPhone in DFU mode ( http://www....

Chosen Solution I had a perfectly good set of Bose Quietcomfort 20 ear buds, battery working well, charging quickly and lasting ages. Whilst in Thailand and charging the battery there was an electrical storm and a power outage (presume surge). When I tried to use the headphones there’s no charge in the battery and it won’t charge. There’s no noise reduction when I turn them on. The green charging light comes on when they’re plugged in but even then there’s no noise reduction....

Chosen Solution Hi guys. I got this iPhone 7 and replaced the whole LCD assembly and now I’m getting light but no image on the screen. I can see some white lines going vertically but apart from that nothing else. This is not the first LCD replacement I make but it is the first time that this has happened. Any tips? Possible faulty LCD, try your old LCD (if it works) to confirm....

Chosen Solution Upon start up the macair gives a tone sound continually - it is not the usual chime - never heard it before. It was brought to a mac store(not Apple store) and I hear they mentioned something about ram, nothing they could do but buy a new machine. I tried zapping PRAM. Does anyone know what this may be? Could it be the ram gone bad, and so a new logic board is required?...